Configuring Interface Isolation

The S2350 and LS-S2326TP-EI-AC   support isolation at Layer 2 and interworking at Layer 3.

Run:
system-view
The system view is displayed.
(Optional) Run:
port-isolate mode { l2 | all }
Interface isolation is configured.
Run:
interface interface-type interface-number
The Ethernet interface view is displayed.
Run:
am isolate { interface-type interface-number }&<1-8>
Unidirectional isolation is configured on the Ethernet interface.
NOTE:
If interface A is isolated from interface B unidirectionally, packets sent from interface A cannot reach interface B, but packets sent from interface B can reach interface A.
Run:
system-view
The system view is displayed.
(Optional) Run:
port-isolate mode { l2 | all }
Interface isolation is configured.
By default, ports are isolated at Layer 2 but can communicate at Layer 3.
Run:
interface interface-type interface-number
The Ethernet interface view is displayed.
Run:
port-isolate enable [ group group-id ]
Interface isolation is enabled on the Ethernet interface.
By default, interface isolation is disabled.
 NOTE:
Interfaces in an interface isolation group are isolated from each other, but interfaces in different interface isolation groups can communicate. If group-id is not specified, interfaces are added to interface isolation LS-S2326TP-SI-AC   group 1.