Configure the SHDSL service.

The MA5600T/MA5683T/MA5608T supports the SHDSL service of multiple encapsulation modes, such as IPoA, PPPoA, IPoE, and PPPoE. This topic uses the PPPoE mode as an example to describe how to configure the SHDSL service. For other encapsulation modes, see "Example: Configuring the xDSL Internet Access Service."

Configure the SHDSL line profile.

To configure the SHDSL line profile, run the shdsl line-profile add or shdsl line-profile quickadd command.

huawei(config)#shdsl line-profile quickadd 10 line two-wire rate 2048 2048 psd

symmetric transmission Annex-A remote disable probe disable snr-margin ds-curr 10 ds-worst

 10 us-curr 10 us-worst 10 bitmap 0x03

Configure the SHDSL alarm profile.

To configure the SHDSL alarm profile, run the shdsl alarm-profile add command.

In this example, the default profile (profile 1) is used.

Configure the SHDSL traffic profile.

To configure the SHDSL traffic profile, run the traffic table ip command.

In this example, the default profile (profile 1) is used.

Activate the SHDSL port.

huawei(config)#interface shl 0/5

huawei(config-if-shl-0/5)#deactivate all

huawei(config-if-shl-0/5)#alarm-config all 1

huawei(config-if-shl-0/5)#activate all 10

huawei(config-if-shl-0/5)#quit

Configure the upstream port.

The SHDSL users of MA5600T/MA5603T/MA5608T-2 use the PPPoE authentication. In this case, the smart VLAN is used to identify the users.

huawei(config)#vlan 3020 smart

huawei(config)#port vlan 3020 0/19 0-1

Add the service port.

Ports 0-15 of the SHDSL board in 0/5 provide the SHDSL services.

To add service ports in batches, run the multi-service-port command.

huawei(config)#multi-service-port vlan 3020 port 0/5 0-15 vpi 0 vci 35

rx-cttr 6 tx-cttr 6