Configure the SHDSL service.

The MA5600 supports the SHDSL Internet access service in multiple encapsulation modes, such as IPoA, PPPoA, IPoE, and PPPoE.

Configure the SHDSL line profile.

To configure the SHDSL line profile, run the shdsl line-profile add or shdsl line-profile quickadd command.

huawei(config)#shdsl line-profile quickadd 10 line two-wire rate 2048 2048 psd symmetric transmission Annex-A remote disable probe disable snr-margin ds-curr 10 ds-worst 10 us-curr 10 us-worst 10 bitmap 0x03

Configure the SHDSL alarm profile.

To configure the SHDSL alarm profile, run the shdsl alarm-profile add command.

In this example, the default profile (profile 1) is used.

Configure the SHDSL traffic profile.

To configure the SHDSL traffic profile, run the traffic table command.

In this example, the default profile (profile 1) is used.

Activate the SHDSL port.

huawei(config)#interface shdsl 0/5

huawei(config-if-shdsl-0/5)#deactivate all

huawei(config-if-shdsl-0/5)#alarm-config all 1

huawei(config-if-shdsl-0/5)#activate all profile-index 10

huawei(config-if-shdsl-0/5)#quit

Configure the upstream port.

The SHDSL users of MA5600-2 use the PPPoE authentication. In this case, the smart VLAN is used to identify the users.

huawei(config)#vlan 1300 smart

huawei(config)#port vlan 1300 0/7 0-1

Add the service port.

Ports 0-30 of the SHDSL board in slot 0/5 provide the SHDSL services. To add service ports in batches, run the multi-service-port command.

huawei(config MA5600T )#multi-service-port vlan 1300 port 0/5 0-31 vpi 0 vci 35 rx-cttr 6 tx-cttr 6