Configuring the Attributes of an Upstream Ethernet Port SmartAX MA5600T

The MA5600T/MA5603U/MA5608T should be interconnected with the upstream device through the Ethernet port. Therefore, pay attention to the consistency of port attributes.

Default Configuration

Ethernet port 0/17/0 is an electrical port. The attribute is as follows: The port rate is 1000 Mbit/s in duplex mode, with supporting flow control, not supporting auto-negotiation function. Do as follows:

huawei(config)#interface 0/17

huawei(config-if-0/17)#auto-neg 0 disable

huawei(config-if-0/17)#speed 0 1000

huawei(config-if-0/17)#duplex 0 full

huawei(config-if-0/17)#flow-control 0

Parameter	Default Setting (Optical Port)	Default Setting (Electrical Port)
Auto-negotiation mode of the port	GICD/GICF/GICK: enabled	Enabled
	Other GIU board: disabled
Port rate	FE optical port: 100 Mbit/s	NA
	GE optical port: 1000 Mbit/s	NOTE:
	10GE optical port: 10000 Mbit/s	After the auto-negotiation mode of the port is disabled, you can configure the port rate.
Duplex mode	Full-duplex, read only	NA
		NOTE:
		After the auto-negotiation mode of the port is disabled, you can configure the duplex mode.
Network cable adaptation mode	Not supported	FE electrical port: auto
		GE electrical port: normal
Flow control	Disabled	Disabled